|
Stainless Steel Twilled Woven Wire Mesh
The Twilled Weave is produced by passing each fill wire alternately over and under two warp wires. The pattern is staggered on successive warp wires, giving the appearance of parallel diagonal lines. This weave allows the use of proportionately heavier wires in a particular mesh count (number of openings per lineal inch) than is possible in plain weave. This cloth has a wide application capable of supporting greater loads and finer filtrations.
Twilled Weave Specifications
|
Aperture (mm) |
Diameter |
Mesh No |
Open Area |
Weight |
|
(mm) |
% |
Kg/M2 |
|
0.066 |
0.036 |
250 |
41.7 |
0.16 |
|
0.062 |
0.04 |
250 |
36.8 |
0.2 |
|
0.058 |
0.036 |
270 |
38.1 |
0.17 |
|
0.055 |
0.03 |
300 |
41.7 |
0.13 |
|
0.054 |
0.04 |
270 |
33 |
0.21 |
|
0.049 |
0.036 |
300 |
33 |
0.19 |
|
0.048 |
0.03 |
325 |
38 |
0.15 |
|
0.043 |
0.03 |
350 |
34.4 |
0.16 |
|
0.042 |
0.036 |
325 |
29.1 |
0.21 |
|
0.039 |
0.025 |
400 |
36.8 |
0.12 |
|
0.034 |
0.03 |
400 |
27.8 |
0.18 |
|
0.025 |
0.025 |
500 |
25 |
0.156 |
Stainless Steel Wire Mesh can be divided into Stainless Steel Wire Mesh Square Opening and Stainless Steel Wire Mesh Dutch Weave according to weaving types, while Square Opening Stainless Steel Wire Mesh can be further divided into square wire mesh plain weave and square wire mesh twill weave.
Stainless Steel Wire Mesh Square Opening usually refers to woven stainless steel wire mesh, in Plain Weave or Twill Weave patterns.
Standard mesh counts per inch for stainless steel wire mesh with square opening:
2mesh/3mesh/4mesh/7mesh/10mesh/12mesh/16mesh /18mesh/20mesh/24mesh/
30mesh/35mesh/40mesh/50mesh/60mesh/70mesh/80mesh/90mesh/100mesh/
120mesh/150mesh /180mesh/200mesh/250mesh/300mesh/325mesh/ 350mesh/
400mesh/450mesh/500mesh
Technical Note:
Standard width of stainless steel wire mesh: 1m or 48"; stainless steel wire mesh with extra roll width of 4m also available.
Standard roll length of stainless steel wire mesh: 30m or 100'.
|
